Manual Call Point

Codesec Addressable Manual Call Point having Light Indication, Resettable by Key, with Embedded Isolator, Can be used as conventional or switch.

Shipping: 1-2 Weeks

A comprehensive range of call points for use with FireClass addressable systems, using the robust and reliable FireClass open protocol. All the call-points are designed to enable an alarm signal to be given by a plastic re-settable element, which means that the call point can be easily reset after it has been activated.

Any change in the status of the switch is immediately communicated to the FireClass Control and Indicating Equipment (CIE). All call points have an integral short-circuit isolator for monitoring the addressable loop wiring.

The integral LED indicator is normally off. When the frangible element is broken, an alarm is registered and the LED will illuminate red. If a section of the loop wiring adjacent to the call point is shorted, the built-in short-circuit isolator trips, isolating the shorted section and the LED is illuminated yellow. The status remains until the short is removed. If required, an optional transparent hinged cover may be installed to guard against accidental operation. Both indoor and outdoor versions are available.

The HCP-DPS incorporates a red LED mounted on the front cover, which can be selected as pulsing/non-pulsing for communications polling and it is continuously lit when the HCP-DPS is operated. The unit is operated by pressing the EN54 compliant non-frangible (plastic) element and, once operated, produces a high level interrupt, allowing the control panel to respond very quickly.

A built in test function initiated by the control panel ensures the integrity of the device at all times and the device can be tested by insertion of a test key in the underside of the unit. Two terminal blocks are provided for easy connection to the loop wiring.

The unit is addressed using the TCH-B100 Hand Held Programmer for quick and reliable addressing and the unit can also be flush mounted if required. An optional glass element is also available.
Incorportes a ‘C Form’ change over contact.

Model HCP-W(SCI) is a weatherproof Manual Call Point with integral short-circuit isolator, which is fully compatible with Hochiki’s ESP analogue addressable protocol.

The unit incorporates a bi-coloured LED, which can be selected as pulsing/non-pulsing for communications polling and is continuously lit when the HCP-W(SCI) is operated – in these two states the LED will show red.

The LED will show amber when a short-circuit is present but will switch to red if the unit is activated.  The unit operates by pressing the EN54 compliant non-frangible (plastic) element and produces a high level ESP interrupt.  A built in test function initiated by the control panel ensures the integrity of the device at all times and the device can be tested by insertion of a test key in the underside of the unit. Two terminal blocks are provided for easy connection to the loop wiring. The unit is addressed using the TCH-B200 Hand Held Programmer.